One of the changes being worked on and is already available in Release-11 is the Band 29. Band 29 is a special FDD band which only has a downlink component and no uplink component. The intention is that this band is available an an SCell (Secondary cell) in CA (Carrier Aggregation).
What this means is that if this is only available as an SCell, any UE that is pre-Rel-11 should not try to use this band. It should not read the system information, reference information, etc. In fact the System Information serves little or no purpose as in CA, the PCell will provide the necessary information for this SCell when adding it using the RRC Reconfiguration message. This gives rise to what 3GPP terms as New Carrier Type for LTE as defined here. An IEEE paper published not long back is embedded below that also describes this feature in detail.
China Mobile, in their Rel-12 workshop presentation, have suggested 3 different types/possibilities for the NCT for what they call as LTE-Hi (Hi = Hotspot and Indoor).
Ericsson, in their Rel-12 whitepaper mention the following with regards to NCT:
Network energy efficiency is to a large extent an implementation issue. However, specific features of the LTE technical specifications may improve energy efficiency. This is especially true for higher-power macro sites, where a substantial part of the energy consumption of the cell site is directly or indirectly caused by the power amplifier.
The energy consumption of the power amplifiers currently available is far from proportional to the power-amplifier output power. On the contrary, the power amplifier consumes a non-negligible amount of energy even at low output power, for example when only limited control signaling is being transmitted within an “empty” cell.
Minimizing the transmission activity of such “always-on” signals is essential, as it allows base stations to turn off transmission circuitry when there is no data to transmit. Eliminating unnecessary transmissions also reduces interference, leading to improved data rates at low to medium load in both homogeneous as well as heterogeneous deployments.
A new carrier type is considered for Release 12 to address these issues. Part of the design has already taken place within 3GPP, with transmission of cell-specific reference signals being removed in four out of five sub frames. Network energy consumption can be further improved by enhancements to idle-mode support.
The IEEE paper I mentioned above is as follows:
